Paintball Gun Maintenance : Paintball Gun Maintenance: Opening

Paintball Gun Maintenance : Paintball Gun Maintenance: Opening


Hi, this is Robert Stewart with hill13.com.
So, you’ve seen how to take the barrel down for a 98, and how we pulled the the feed off.
The other thing we referred to is to take the screws loose from the adapter for the
air tank. We’re going to take those two screws out now, and I always make sure to have a
little small cup or a bag or something just to make sure you don’t end up with one screw
short at the end of the day; to keep all the screws in. So now that the air is loose from
the grip, we unscrew with an Allen Wrench all of the screws that hold the receiver together;
make sure that they’re all completely loose, which I believe we have them all loose and
now we can remove the left side of the receiver. And again, all of these screws; if they don’t
stay in, if you can keep them in and just set it to the side for the time being, that’s
fine; otherwise, if you’re afraid you’re going to mix and match leave them in. Otherwise,
secure them in your bag. Now we’re ready to look at the bolt and deal with the maintenance
on the bolt.

Leave a Reply

Your email address will not be published. Required fields are marked *