Kingman Spyder Paintball Cup Seal Replacement

Kingman Spyder Paintball Cup Seal Replacement


today, I’ll be showing you how to repair lee that may be caused by the cubs heel if your marker seems to link down the Barrel or up out of the fee neck these are signs that the cubs still needs to be replaced First you’ll want to remove the barrel to remove the barrel unscrew it counterclockwise Then you’ll want to get the three millimeter wrench So you can remove the edge safe for the trigger plate there are two set screws a whole day [is] in place So go ahead and loosen those up once you have those news you should be able to lift up the A-SI And remove the set screws Go ahead and set those aside Now that the Asa’s loosen the hose line is loose. You should be able to unscrew the regulator from the vertical adapt Once you have the regulator off you want to get your formula meter wrench And remove the vertical screw on the [vertical] adapter Once you have it slightly loose. Go ahead put your finger on the front plug because it does [have] spring tension behind it Once you remove the vertical adapter keep in [mind] that there is an o-ring on the vertical adapter, and you don’t want to lose that Then once the plug pops out go ahead and pull [it] You have your valve Spring? Cups heal without pit go ahead and remove the spring from the cup seal And go ahead and unscrew The cap seal from the valve pick to unscrew the cup soup from the valve in go ahead and turn it counterclockwise Once you have [the] tub seal removed go ahead and replace [it] with a cups and a spare horse kick to Reinstall it turn clockwise And put on hand tight once you have that together go ahead [and] grab the valve Spring and front plug Connect the valve Spring And make sure that the front plug threads are facing towards the bottom portion of the body on the market When you go to insert develop in make sure that it lines up inside the valve body slides all the way in Once you have that lined up go ahead and line up the threads for the front plug So it matches the hole on the bottom of the market Then you grab your vertical adapter with the screw make sure that the o-ring is still in place And lock it in to the front plug Once you have that set Go ahead and sign the vertical screen and this one you want to put on fairly tight Once you have that tightened on go ahead and grab your regulator And screw that on to the vertical adapter Once you have that screwed on go ahead and line up the [heisei] back with the bottom of the Trigger frame grab the two set screws for the bottom line And tie them back up now the guns ready to be tested for an air

Leave a Reply

Your email address will not be published. Required fields are marked *